Wednesday, February 4, 2015

Robot Club - fourth session completed


Link to Preparing post details in the parts in the kits.: http://winkleink.blogspot.co.uk/2014/11/preparing-for-2015-after-school.html

Link to First session; http://winkleink.blogspot.co.uk/2015/01/robot-club-first-session-completed.html

Note; I did not post for the second session. There is a short summary in the Third Session post.
Link to Third session: http://winkleink.blogspot.co.uk/2015/01/robot-club-third-session-completed.html

This week we nearly had a full house.
Only 1 child missing due to illness.

The 4 who attended the previous week remember a lot of their work and code so were getting stuck into getting their robots to go around a corner.

I had a bit more fun getting drivers on enough school PCs to permit the Arduino Nano to be seen. It needs custom USB/Serial drivers that are not included by default.

The teacher who is ICT coordinator came in to see the session in full swing with robots spinning, or moving along the floor. With coding going on and due to plus and minus lines on the batteries being shorted a nice little display of black smoke and the lovely smell of burnt plastic.
No real harm done just a jumper wires plastic sleeving was melted.
I congratulated the child on making smoke as it's something we all do when we work with electronics.  They were kind of shocked.
It was great that the teacher had the same attitude so no harm done and no concern about burning down the school.
I tested their robot kit and Arduino. Nothing damaged, amazingly so did a little bit of rewiring and handed them back their robot to get working on again.

On of the kids who was in the previous session had a problem where their robot was pulling to the left.  These are small cheap kits so the motors aren't tuned and the wheels are small and have grip meaning they catch on the carpet.  Meaning they cannot reliably go straight.
We tried to fix it by turning the wheels in or our to change the resistance but no go so introduced that child to analogWrite.
A value of 235 seemed to make it all work perfectly. They had a nice straight running robot.

Once again the kids were not that eager to leave as they were perfecting their code and making it better.

At the end one of the girls who was being collected wanted to show her mother what she had done so she gave a great demonstration of her robot.  Holding down reset to stop it moving.
Set it up and let it go. She then explained the code she had made as well as giving details on some of the other parts we will be using.

Next week we will be using an input device. A small line following sensor. I will mark the edge of the room area with white paper providing a contrast with the blue flooring. The idea will be to detect the paper and make the robot turn.
This will be the first time the kids do inputs and will also require the introduction of the 'if' statement.

Looking forward to another productive session next Monday.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.